Displaying The Time Code - Sony PVM-L2300 Operation Manual

Audio level
1 2 3 4
Channel number
The level meters of eight channels including the
selected channel are displayed.
To cancel the display of the audio level meter
Set Audio Level Meter (page 64) to Off in the Function
Switch menu of the Display Function menu or by pressing
the Audio Level Meter button* of the controller.
* Audio Level Meter and ALM Hold Reset are assigned to the
function buttons of the controller in the Function Key menu (page
78) of the Controller menu.
Note
Use the controller with software version 1.4 or higher to
assign Audio Level Meter or ALM Hold Reset function to
the function button of the controller.
90

Displaying the Time Code

Audio level
(dB)
OVER
0
-10
-20
-30
-60
5 6 7 8
Displaying the Time Code
The time code superimposed on the SDI signals is
displayed by installing the optional input adaptor (BKM-
250TG).
Note
As the time code is superimposed on the video signal, the
time code may be invisible partially because of the scan
mode setting of the monitor.
1
Input the SDI signal.
2
Select the channel.
3
Set the time code in the Time Code menu (page 70) of
the On Screen Set menu of the System Configuration
menu.
To set the type of the time code
Set in the VITC/LTC menu.
VITC: Sets to VITC.
LTC: Sets to LTC.
To set the display position for the time code
Set in the Position menu.
Top Left: To display it at top left on the screen
Top Center: To display at top center on the screen
Top Right: To display at top right on the screen
Bottom Left: To display at bottom left on the screen
Bottom Center: To display at bottom center on the
screen
Bottom Right: To display at bottom right on the
screen
4
Set Time Code (page 65) to On in the Function Switch
menu of the Display Function menu or by pressing the
Time Code button* of the controller.
The time code is displayed.
To cancel the time code display
Set Time Code (page 65) to Off in the Function Switch
menu of the Display Function menu or by pressing the
Time Code button* of the controller.
* Time Code is assigned to the function button of the controller in
the Function Key menu (page 78) of the Controller menu.
Note
Use the controller with software version 1.4 or higher to
assign Time Code function to the function button of the
controller.