Setting The Display Of Native Scan Mode - Sony PVM-L2300 Operation Manual

Setting the Display of
Native Scan Mode
About the native scan mode
You can set the picture display type for the native scan
mode according to the input signal.
You can select ×1 or ×2, which differ in picture display
size, to map the pixels of the signal to the panel in one-to-
one mode, or Aspect Correction. An SD signal of non-
square pixels (the number of H pixels of the signal system
is 720 or 1440) or a 640 × 480 SD signal of DVI
video/HDMI video is displayed correctly by scaling
processing of doubling for the V direction and correct
aspect ratio for the H direction, and the picture is also
optimized and displayed by modifying the aperture
coefficient value, filter coefficient value, etc. in Aspect
Correction mode.
For details, see "Picture Display Size" on page 109.
Set the native scan mode in the Native Scan Mode menu
(page 57) of the Display Setting menu.
Note
The native scan is not selectable in the following cases:
• When the input signal has no sync signal
• When Side by Side is set to On
• When Pixel Zoom is set to on
• When Format of the Input Configuration menu is set to
DVI Computer (The native scan is displayed regardless
of the setting.)
• When the HDMI computer signal is input (The native
scan is displayed regardless of the setting.)
• When the signal system is the SD signal of 720 × 576 or
1440 × 576, Native Scan Mode is set to Aspect
Correction and the internal signal of the aspect ratio 16:9
is displayed (Native Scan is set to Off and the normal
scan is displayed regardless of the setting.)
Display of the input signal system 576/50i
or 576/50P
When the input signal system is the 720 × 576 or 1440 ×
576 SD signal, the Native Scan Mode is set to Aspect
Correction and the aspect ratio is 16:9, you can display no
display area of the left and right sides over the H size
(1920) by sliding the picture with the PHASE knob of the
controller. You can restore the display position to the
center by pressing the MANUAL button of PHASE of the
controller.
Displayed by sliding the picture with the
PHASE knob of the controller.
To display the whole picture of the V
direction, remove the 16:9 frame.
Note
The set position is held even when the system is changed to
another input signal system.

Setting the Display of Native Scan Mode

83