Selecting The Native Scan/Scan Mode - Sony PVM-L2300 Operation Manual

Selecting the Native
Scan/Scan Mode
You can select scan mode from a native scan that maps the
pixel of the signal to the panel in one to one mode, under
scan (–3%), normal scan (0%) and over scan (mask of 5%
over scan portion in the normal scan picture).
You can set scan mode with the NATIVE SCAN button or
SCAN button of the controller, or in the Function Switch
menu of the Display Function menu.
Setting with the NATIVE SCAN button or
SCAN button of the controller
To set to the native scan mode
Set the NATIVE SCAN button to on. (The LED on the
button lights.)
To select the scan mode
1
Set the NATIVE SCAN button to off. (The LED on
the button is turned off.)
2
Press the SCAN button to select the scan mode.
Scan mode is changed to normal, under and over scan
mode by each press of the button.
Setting in the menu
Set Scan Mode or Native Scan in the Function Switch
menu of the Display Function menu.
iiFunction Switch
Scan Mode: xxx
Native Scan: xxx
16:9: xxx
H Delay: xxx
V Delay: xxx
External Sync:: xxx
Comb: xxx
To set to the native scan mode
Set Native Scan to On.
To select the scan mode
1
Set Native Scan to Off.
2
Select Scan Mode, then select scan mode from the
following.
Normal Scan: Normal mode
84

Selecting the Native Scan/Scan Mode

v
1/4
V
Under Scan: Under mode
Over Scan: Over mode
For details on the Function Switch menu, see "Function
Switch" (page 62) in the Display Function menu.
Note
The scan mode is not selectable in the following cases:
• When Native Scan is set to On
• When the internal signal is displayed
• When Side by Side is set to On