Hose & Regulator Specifications And Installation - Brinkmann Select 810-6680-S Owner's Manual

6 burner gas grill parrilla a gas con 6 quemadores
Hide thumbs Also See for Select 810-6680-S:
Table of Contents

Advertisement

Available languages

Available languages

LP GAS CYLINDER (TANK) RUBBER SEAL INSPECTION:
Inspect the propane tank valve rubber seal for cracks,
wear or deterioration prior to use. A damaged rubber
seal can cause a gas leak, possibly resulting in an
explosion, fi re or severe bodily harm.
Inspection should be done each time the propane tank
is connected to the grill, has been refi lled, exchanged or
has not been used for more than 60 days.
Do not use a propane tank with a damaged rubber seal.
Exchange the tank or have the rubber seal replaced at a
qualifi ed propane fi lling station.
INSTALLING THE LP GAS CYLINDER (TANK) ONTO THE GRILL:
1. Check that the cylinder valve is closed by turning the knob clockwise.
2. Place the cylinder into the tank holder in the bottom of cabinet.
3. Orient the cylinder such that the valve opening faces the left side table,
so that the hose is not kinked or damaged.
4. Fully tighten the tank retention screw underneath tank holder to secure tank.
HOSE & REGULATOR SPECIFICATIONS AND INSTALLATION:
DO NOT attempt to connect grill, as purchased for LP (propane) gas, to any other fuel supply
source such as a natural gas line. For dual fuel grills that can be converted to natural gas, a
Brinkmann conversion kit must be purchased and installed for use with natural gas. Please
contact Brinkmann Customer Service at 800-527-0717 to see if your grill can be converted.
DO NOT use any other pressure regulator/hose assembly other than the one supplied with your grill.
Replacement pressure regulator/hose assembly must be part No 155-6680-0, which can be obtained
by contacting customer service at 800-527-0717 .
DO NOT attempt to adjust or repair a regulator. The regulator is designed to operate at a
maximum output pressure of 11 inches of water column (2.74 kPa).
Ensure the tank valve is CLOSED prior to connecting the LP gas cylinder to your grill. Turn the
valve knob clockwise to properly close the valve. Read and follow all instructions and warnings
on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe
use of LP gas cylinders and the hose and regulator before connecting cylinder to grill. Read and
follow all warnings on the LP cylinder.
Tank Holder
WARNING
Good
Damaged
Rubber Seal
Rubber Seal
Tank Retention Screw
8

Advertisement

Chapters

Table of Contents
loading

Table of Contents