Brinkmann Series 2630 Owner's Manual
  1. Manuals
  2. Brands
  3. Brinkmann Manuals
  4. Grill
  5. Series 2630
  6. Owner's manual

Brinkmann Series 2630 Owner's Manual

Natural gas stainless steel outdoor girll
Hide thumbs
Table of Contents

Advertisement

Quick Links

ASSEMBLY AND OPERATING INSTRUCTIONS
SAVE THIS MANUAL FOR FUTURE REFERENCE
NOTICE TO INSTALLER:
LEAVE THESE INSTRUCTIONS
WITH THE GRILL OWNER FOR
FUTURE REFERENCE.
OWNER'S MANUAL
GRILL LIGHTING INSTRUCTIONS:
1. Read and follow all warnings and instructions
in owner's manual before lighting.
2. Open lid before lighting burner.
3. Make sure all control knobs are in the OFF position.
4. Select the burner to be lit. Push and turn the control
knob of that burner to HIGH.
OFF
OFF
HIGH
HIGH
FOR OUTDOOR USE ONLY
LOW
LOW
Stainless Steel
Outdoor Grill
SIDE BURNER
5. Press the electronic igniter and hold for 3-5
7. Repeat Steps 4-6 for lighting each burner. Always
LIGHTING
seconds to light burner.
use electronic igniter for lighting each burner.
INSTRUCTIONS:
6. If burner does NOT ignite immediately, turn control
8. Refer to owner's manual for match lighting procedure.
knob to OFF, wait 5 minutes to allow gas to
9. For assistance, call 1-800-527-0717.
1. Follow Steps
dissipate and repeat lighting procedure.
10. To turn off, turn control knobs clockwise until it locks
1-3 in GRILL
in OFF position.
OFF
OFF
LIGHTING
INSTRUCTIONS.
2. Push and turn
SIDE BURNER
control knob to
HIGH
HIGH
HIGH.
3. Follow Steps
5-10 in GRILL
LIGHTING
LOW
LOW
WARNING
HAZARDOUS EXPLOSION MAY
RESULT IF THESE WARNINGS AND
INSTRUCTIONS ARE IGNORED. READ
AND FOLLOW ALL WARNINGS AND
INSTRUCTIONS IN THIS MANUAL TO
AVOID PERSONAL INJURY, INCLUDING
DEATH OR PROPERTY DAMAGE.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Series 2630 and is the answer not in the manual?

Questions and answers

Related Manuals for Brinkmann Series 2630

Summary of Contents for Brinkmann Series 2630

  • Page 1 OWNER’S MANUAL ASSEMBLY AND OPERATING INSTRUCTIONS SAVE THIS MANUAL FOR FUTURE REFERENCE NOTICE TO INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE GRILL OWNER FOR FUTURE REFERENCE. Stainless Steel Outdoor Grill GRILL LIGHTING INSTRUCTIONS: 1. Read and follow all warnings and instructions 5.

  • Page 2: Important Safety

    IMPORTANT SAFETY WE WANT YOU TO ASSEMBLE AND USE YOUR GRILL AS SAFELY AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL ATTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR GRILL. WHEN YOU SEE THE SAFETY ALERT SYMBOL PAY CLOSE ATTENTION TO THE INFORMATION WHICH FOLLOWS! READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING AND OPERATING YOUR GRILL.
  • Page 3 Never use liquid propane gas (LP) in a unit designed for natural gas. • Never use charcoal briquets or lighter fluid in a gas grill. • Leak test all connections before first use, even if grill was purchased fully assembled and after each time the hose is connected to the natural gas supply.

  • Page 4: Installation Information

    • FOR OUTDOOR USE ONLY. DO NOT operate indoors or in an enclosed area such as garage, shed or breezeway. • Use your grill OUTDOORS in a well ventilated space away from dwellings or other buildings to prevent dangers associated with gas accumulation and toxic vapors. We recommend your grill be situated at least 10 feet from buildings.

  • Page 5: Connecting Your Grill To The Natural Gas Source

    • Visually inspect the hose assembly prior to each use for evidence of damage, excess wear or deterioration. If found, replace the assembly before using your grill. Only the Brinkmann supplied replacement should be used. Insert cover when hose is disconnected...

  • Page 6: Leak Testing

    LEAK TESTING: To prevent fire or explosion hazard: • DO NOT smoke or permit ignition sources in the area while conducting a leak test. • Perform test OUTDOORS only in a well ventilated area. • Never perform a leak test with a match or open flame. •...

  • Page 7: Pre-Start Checklist

    6. Check each place listed (A -G) for growing bubbles which indicates a leak. 7. Turn OFF gas supply at natural gas supply. 8. Turn on control knobs to release gas pressure in hose. 9. Turn control knobs to OFF position. 10.

  • Page 8: Lighting Instructions

    LIGHTING INSTRUCTIONS: Follow the instructions exactly. 1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down. 2. Check that all burner control knobs and the natural gas supply are turned to the OFF position. 3.

  • Page 9: Lighting The Side Burner

    LIGHTING THE SIDE BURNER: 1. Open lid to the side burner before lighting. 2. Turn on the side burner by pressing in and rotating the control knob to the HIGH position. 3. Press and hold the igniter button on the main control panel for 3-5 seconds until the burner ignites.

  • Page 10: Controlling Flare-Ups

    CONTROLLING FLARE-UPS: • Flare-ups are a part of cooking meats on a gas grill. This adds to the unique flavor of cooking on a gas grill. Excessive flare-ups can over-cook your food and cause a dangerous situation for you and your grill.

  • Page 11: Rotisserie Cooking

    ROTISSERIE COOKING: • Your grill was pre-drilled from factory to include mounting holes for a Brinkmann rotisserie (sold separately). Do not use a rotisserie not specifically manufactured for this grill. • Read and follow all instructions provided with the rotisserie. Save instructions for future reference.

  • Page 12: Transporting And Storage

    If storing the grill indoors, disconnect the hose from the natural gas supply. • If storing the grill outdoors, cover the grill with a grill cover for protection from the weather. A grill cover can be purchased by contacting: The Brinkmann Corporation at 1-800-527-0717. CLEANING AND MAINTENANCE: •...

  • Page 13: Cooking Grills

    BURNER ASSEMBLY/MAINTENANCE • Although your burners are constructed of cast iron, they may rust as a result of the extreme heat and acids from cooking foods. Regularly inspect the burners cracks, abnormal holes, and other signs of corrosion damage. If found, replace the burner. •...

  • Page 14: Troubleshooting

    TROUBLE SHOOTING: Problem: • Burner will not light • Fire at control knobs • Yellow Flames at burner • Flame blows out on “LOW” • Grill is Too Hot Possible Causes: 1. Check natural gas supply. 2. Bad electrode spark. Check to see if the grill will “match light.”...

  • Page 15: Proper Care And Maintenance

    • To protect your grill from excessive rust, the unit must be kept clean and covered at all times when not in use. A grill cover may be ordered directly from Brinkmann by calling 1-800-468-5252 or 1-800-527-0717. • Wash cooking grills and heat shields with hot, soapy water, rinse well and dry. Lightly coat cooking grill with vegetable oil or vegetable oil spray.

  • Page 16: Parts List

    READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING OR OPERATING YOUR GRILL. WE RECOMMEND TWO PEOPLE WORK TOGETHER WHEN ASSEMBLING THIS UNIT. The following provided tools are required to assemble this Brinkmann Pro Series 2630 Grill: • Flathead Screwdriver • Hex Nut Wrench...
  • Page 17 FOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT 1-800-527-0717. (Proof of purchase will be required.) Inspect contents of the box to ensure all parts are included and undamaged.
  • Page 18 PARTS CARD CONTENTS Make sure you have all items listed under PARTS LIST and PARTS BAG CONTENTS before you begin the installation process. Your Parts Bag will include: Qty. M6 X 12mm bolts M6 X 20mm bolts M6 X 60mm bolts AA /1.5V Alkaline battery M6 X 12mm bolts #10 X 1/2 self...
  • Page 19 Locking Caster Hex Nut Wrench Choose a good, cleared assembly area and get a friend to help you put your grill together. Lay cardboard down to protect grill finish and assembly area. Step 1 Assemble bottom cart panel and right side cart panel assembly by using four M6 X 60mm bolts (hand tighten only at this point).
  • Page 20 Step 4 Attach back cart panel by using six M6 X 60mm bolts. Note: Leave bolts hand tight until Step 11. Step 5 Install door bracket using the four #10 X 1/2” self taping screws. Make sure door stop is set toward back of cart.
  • Page 21 Grease Tray Bracket °F GRILL LIGHTING INSTRUCTIONS: 1. Read and follow all warnings and instructions 5. Press the electronic igniter and hold for 3-5 7. Repeat Steps 4-6 for lighting each burner. Always in owner’s manual before lighting. seconds to light burner. use electronic igniter for lighting each burner.
  • Page 22 Step 9 Attach side burner assembly to grill body assembly by inserting four M6 X 20mm bolts through the holes in the side burner assembly and into holes of grill body assembly. Tighten all four bolts. Install side burner grate and control knob.
  • Page 23 Side Table Tool Drawer Screw Holes Step 12 Attach side table/ice bucket assembly to grill body assembly by inserting four M6 X 20mm bolts through the holes in the side table/ice bucket assembly and into holes of grill body assembly. Tighten all four bolts.
  • Page 24 Step 14 Insert grill bottom into opening on backside of grill. Make sure to slide tray onto tracks as illustrated. Step 15 Slide grease tray into grease tray bracket located under grill bottom on backside of grill. Step 16 Hang stainless steel bucket in cut- out of left side table/ice bucket assembly.
  • Page 25 Warming Rack Cooking Grills Stainless Steel Heat Shields Pro Series 2630 (Assembled) GRILL LIGHTING INSTRUCTIONS: SIDE BURNER 1. Read and follow all warnings and instructions 5. Press the electronic igniter and hold for 3-5 7. Repeat Steps 4-6 for lighting each burner. Always LIGHTING in owner’s manual before lighting.
  • Page 26 RIB RACK Chrome-plated rack can greatly increase the cooking capacity of your grill. Holds ribs, chicken halves, potatoes and corn vertically to triple cooking capacity. Allows smoke, steam and heat to penetrate food evenly. 812-3310-0 MEATLOAF BASKET The unique basket weave prevents meatloaf from falling through the grill while allowing smoke, steam and heat to flow into the food.
  • Page 27 Restaurant-style aluminum fry pan with nickel plated wire straining basket is an essential tool for frying fish, chicken, french fries, onion rings and more. Strainer basket holder helps drain excess oil. Use outdoors with the Brinkmann Backyard Kitchen and avoid the mess and odor of frying indoors.

  • Page 28: Warranty

    • This warranty does not cover surface scratches, rust or heat damage to the finish, which is considered normal wear. • The Brinkmann Corporation may elect to repair or replace damaged units covered by the terms of this warranty. • This warranty extends to the original purchaser only and is not transferable or assignable to subsequent purchasers.

This manual is also suitable for:

Proseries 2630810-2630-0

Table of Contents

Save PDF