Hose & Regulator Specifications And Installation - Brinkmann 810-6420-S Assembly And Operating Instructions Manual

4 burner gas grill
Table of Contents

Advertisement

Available languages

Available languages

LP GAS CYLINDER (TANK) RUBBER SEAL INSPECTION:
Inspect the propane tank valve rubber seal for cracks,
wear or deterioration prior to use. A damaged rubber seal
can cause a gas leak, possibly resulting in an explosion,
fi re or severe bodily harm.
Inspection should be done each time the propane tank
is connected to the grill, has been refi lled, exchanged or
has not been used for more than 60 days.
Do not use a propane tank with a damaged rubber seal.
Exchange the tank or have the rubber seal replaced at a
qualifi ed propane fi lling station.
INSTALLING THE LP GAS CYLINDER (TANK) ONTO THE GRILL:
1. Check that the cylinder valve is closed by turning the knob clockwise. Inspect cylinder valve rubber seal
for cracks or deterioration. Do not use propane tank with damaged seal as a gas leak may occur.
2. Place the cylinder into the notches of the tank holder on the bottom of right legs.
3. Orient the cylinder such that the valve opening faces the right side of the grill, and the hose is not kinked
or damaged. Then slide tank brace over cylinder handle and secure tightly.
Tank Support
Bracket
HOSE & REGULATOR SPECIFICATIONS AND INSTALLATION:
DO NOT attempt to connect grill, as purchased for LP (propane) gas, to any other fuel supply
source such as a natural gas line. A Brinkmann conversion kit must be purchased and installed
for use with natural gas.
DO NOT use any other pressure regulator/hose assembly other than the one supplied with your grill.
Replacement pressure regulator/hose assembly must be part No 155-6420-0, which can be obtained
by contacting customer service at 800-527-0717.
DO NOT attempt to adjust or repair a regulator. The regulator is designed to operate at a maxi-
mum output pressure of 11 inches of water column (2.74 kPa).
Ensure the tank valve is CLOSED prior to connecting the LP gas cylinder to your grill. Turn the
valve knob clockwise to properly close the valve. Read and follow all instructions and warnings
on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe
use of LP gas cylinders and the hose and regulator before connecting cylinder to grill. Read and
follow all warnings on the LP cylinder.
Tank
Heat
Shield
Tank Support Bracket
WARNING
Good
Rubber Seal
Tank Brace
Damaged
Rubber Seal
6

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents