Table of Contents
Advertisement
ZDV3318/ZDV3622 - HOW TO INSTALL CLEAN VIEW KIT (CVCK)
Installing Clean View Kit (CVCK)
For ZDV3318/ZDV3622/ZDV6000/ZDV3320/MQZDV3318/MQZDV3622
1.
Install optional fan kit (See Fan Instructions)
2.
(a)All styles except ZDV6000 & ZDV3320. Make sure small standoff is folded up and fastened into position. If not fold standoff
up into position and fasten with supplied screws. (Fig 1)
(b) For ZDV6000 & ZDV3320 only. Fold eight inch standoff up into position and install with supplied screws. Do not remove
small standoff. The eight inch standoff will fit over the top of the small standoff. (Fig 1)
3.
For ZDV6000 & ZDV3320 only. All others skip to Step 4.
Using screws provided, fasten the non-combustible header onto the top of CVCK assembly.
4.
Hang CVCK onto top of fireplace retainer tabs and rotate into position. (Fig 2)
5.
Using [4] supplied #6 screws, fasten CVCK kit to the inside frame of unit.
Note:
Holes are pre-punched into side frame of unit, one hole at the top and one at the bottom.
6.
Using [10] supplied screws, install the top heat shield to the top inner side of CVCK. (Fig 3 )
Note:
It will be easier to install leading edge screws first and side screws last. Some pressure will be required when installing
side screws to push top edge up into unit.
7.
Kit is supplied with 2 valve extension knob. Align the notches and slide extension knobs onto valve knobs.
8.
DO NOT brick or tile beyond the inside area of the CVCK kit to allow for removal of door
13
Advertisement
Table of Contents
