Chapter 7 Supplying The Power - OSEE LMD9014 User Manual

Chapter 7 Supplying the power
An Anton/Bauer or V-mount type of battery pack (Optional units) or an external DC power supply can be
used to power this monitor.
u Using the Anton/Bauer type of battery pack
1. Install the Anton/Bauer type of battery pack.
2. Insert the battery pack. And slide it in the direction of the arrow.
To remove the battery pack, slide it in the opposite direction to the one in which it was
attached while keeping the release lever on the battery holder pulled down all the way.
u Using a V-mount type of battery pack
Caution: These servicing instructions are for use by qualified service personnel only. To reduce the risk
of electric shock, do not perform any servicing other than that contained in the operating instructions
unless you are qualified to do so.
1. Remove the battery holder.
2. Loosen the six screws (length 10mm X M3) of the V-mount type battery holder to unpack it.
3. Fix the bottom of V-mount type battery holder with four screws (length 9mm X M3) supplied
with the holder.
4. Install the accessory battery mount terminal block.
5. Fasten the other of V-mount type battery holder with four screws (length 10mm X M3) on the
original position.
6. Insert the battery pack. And side it in the direction of the arrow.
To remove the battery pack, slide it in the opposite direction to the one in which it was
attached while keeping the release lever on the battery holder pulled down all the way.
u Connect the external DC power supply to the DC IN socket on this unit.
Caution:
If an external DC power supply is used, then check the ratings of the external DC power supply
so that they are compatible with those of this unit.
Check the pin arrangement of the DC output terminal of the external DC power supply and those
of the DC IN socket of this unit so that their polarities are correctly arranged.
If +12V are supplied to the unit's GND terminal by mistake, this may cause fire or injury.
LMD9014 LCD MONITOR User Manual
—23—