Configuring Cisco Wap351 Setup Wizard - Cisco WAP131 Administration Manual

Getting Started
Using the Access Point Setup Wizard
STEP 13
STEP 14
STEP 15
STEP 16
STEP 17
STEP 1
STEP 2
STEP 3
STEP 4
Cisco WAP131 and WAP351 Administration Guide
We recommend that you assign a different VLAN ID from the default (1) to wireless
traffic, in order to segregate it from management traffic on VLAN 1.
Click Next. Repeat the step 7 to step 12 to configure the settings for Radio 2
interface.
Click Next. The Summary - Confirm Your Settings window appears.
Review the settings that you configured. Click Back to reconfigure one or more
settings. If you click Cancel, all settings are returned to the previous or default
values.
If they are correct, click Submit. Your WAP setup settings are saved and a
confirmation window appears.
Click Finish.
The WAP device was configured successfully. You are required to log in again with
the new password.

Configuring Cisco WAP351 Setup Wizard

Follow these steps to complete the wizard (you must log in again after changing
your password):
Click Next on the Welcome page of the wizard. The Configure Device - IP Address
window appears.
Click Dynamic IP Address (DHCP) if you want the WAP device to receive an IP
address from a DHCP server, or click Static IP Address to configure the IP
address manually. For a description of these fields, see
Click Next. The Single Point Setup — Set A Cluster window appears. For a
description of Single Point Setup, see
To create a new Single Point Setup of the WAP device, click Create a New Cluster
and enter a New Cluster Name. When you configure your devices with the same
cluster name and enable the Single Point Setup mode on other WAP devices, they
automatically join the group.
IPv4
Single Point Setup.
1
Setting.
13