Cisco WAP131 Administration Manual page 126

Quality of Service
Class Map
Cisco WAP131 and WAP351 Administration Guide
49152 to 65535—Dynamic and/or Private Ports
- Mask—The port mask. The mask determines which bits are used and
which bits are ignored. Only the hexadecimal digit (0-0xFFFF) is allowed.
1 means the bit matters and 0 means that we should ignore this bit.
• Destination IP—Requires a packet's destination IPv4 address to match the
IPv4 address defined in the appropriate fields.
- Destination IP Address—Enter the IPv4 address to apply this criteria.
- Destination IP Mask—Enter the destination IP address mask.
• Destination Port—Includes a destination port in the match condition for the
rule. The destination port is identified in the datagram header.
- Select From List—Matches the destination port in the datagram header
with the selected keyword: ftp, ftpdata, http, smtp, snmp, telnet, tftp,
www. Each of these keywords translates into its equivalent port number.
- Match to Port—Matches the destination port in the datagram header
with an IANA port number that you specify. The port range is from 0 to
65535 and includes three different types of ports:
0 to 1023—Well Known Ports
1024 to 49151—Registered Ports
49152 to 65535—Dynamic and/or Private Ports
- Mask—The port mask. The mask determines which bits are used and
which bits are ignored. Only the hexadecimal digit (0-0xFFFF) is allowed.
1 means the bit matters and 0 means that we should ignore this bit.
• Service Type—Specifies the type of service to use in matching the packets
to the class criteria.
- IP DSCP Select From List—Choose a DSCP value to use as a match
criterion.
- IP DSCP Match to Value—Enter a custom DSCP value from 0 to 63.
- IP Precedence—Matches the packet's IP precedence value to the IP
precedence value defined in this field. The IP precedence range is from
0 to 7.
7
129