Table of Contents
Advertisement
Quality of Service
Class Map
Cisco WAP131 and WAP351 Administration Guide
•
Protocol—Uses a Layer 3 or Layer 4 protocol match condition based on the
value of the IP Protocol field in IPv4 packets or the Next Header field in IPv6
packets. Choose the protocol to match by keyword or enter a protocol ID:
-
Select From List—Matches the selected protocol: IPv6, ICMPv6, TCP,
UDP.
-
Match to Value—Matches a protocol that is not listed by name. Enter the
protocol ID. The protocol ID is a standard value assigned by IANA. The
range is a number from 0 to 255.
•
Source IPv6—Requires a packet's source IPv6 address to match the IPv6
address defined in the appropriate fields.
-
Source IPv6 Address—Enter the IPv6 address to apply this criteria.
-
Source IPv6 Prefix Length—Enter the prefix length of the source IPv6
address.
•
Source Port—Includes a source port in the match condition for the rule. The
source port is identified in the datagram header.
-
Select From List—Matches a keyword associated with the source port:
ftp, ftpdata, http, smtp, snmp, telnet, tftp, www. Each of these keywords
translates into its equivalent port number.
-
Match to Port—Matches the source port number in the datagram header
to an IANA port number that you specify. The port range is from 0 to
65535 and includes three different types of ports:
0 to 1023—Well-Known Ports
1024 to 49151—Registered Ports
49152 to 65535—Dynamic and/or Private Ports
-
Mask—The port mask. The mask determines which bits are used and
which bits are ignored. Only the hexadecimal digit (0 to 0xFFFF) is
allowed. 1 means the bit matters and 0 means that we should ignore this
bit.
•
Destination IPv6—Requires a packet's destination IPv6 address to match
the IPv6 address defined in the appropriate fields.
-
Destination IPv6 Address—Enter the IPv6 address to apply this criteria.
-
Destination IPv6 Prefix Length—Enter the prefix length of the
destination IPv6 address.
7
131
Hide quick links:
Advertisement
Table of Contents
