Access Points; Configuring The Wap Device For Single Point Setup - Cisco WAP131 Administration Manual

Single Point Setup

Access Points

Access Points
STEP 1
STEP 2
Cisco WAP131 and WAP351 Administration Guide
WorkGroup Bridge
Use the Access Points page to enable or disable Single Point Setup on the WAP
device, view the cluster members, and configure the location and cluster name for
a member. You can also click the IP address of a member to configure and view
data on that device.

Configuring the WAP Device for Single Point Setup

To configure the location and name of an individual Single Point Setup cluster
member:
Select Single Point Setup > Access Points.
Single Point Setup is disabled on the WAP device by default. When it is disabled,
the Enable Single Point Setup button is visible. If Single Point Setup is enabled,
the Disable Single Point Setup button is visible. You can edit the Single Point
Setup settings only when Single Point Setup is disabled.
Icons on the right side of the page indicate whether Single Point Setup is enabled
and, if it is, the number of the WAP devices that are currently joined in the cluster.
With Single Point Setup disabled, configure these parameters for each individual
member of a Single Point Setup cluster:
• Location—Enter a description of where the WAP device is physically
located, for example, Reception. The location field is optional.
• Cluster Name—Enter the name of the cluster for the WAP device to join, for
example Reception_Cluster. The cluster name is not sent to other WAP
devices. You must configure the same name on each device that is a
member. The cluster name must be unique for each Single Point Setup that
you configure on the network. The default is ciscosb-cluster.
• Clustering IP Version—Choose the IP version that the WAP devices in the
cluster use to communicate with other members of the cluster. The default is
IPv4.
11
175