Armrest Width - Pride Mobility Jazzy 1110 Owner's Manual

V . C O M F O R T
After you have become familiar with your Jazzy’s operation, you may find the need to make adjustments to the
Jazzy’s seat. There are some adjustments you can make to increase your comfort such as seat height and angle,
armrest height and angle, the footrest height and angles, and the joystick position.
WARNING ! If your Jazzy 1113 was configured at your authorised Pride Dealer or service center,
please consult your health care professional before changing seat position or making any other
adjustment. Some of these adjustments may degrade your Jazzy’s performance and safety by
changing its center of gravity.
SEAT HEIGHT AND ANGLE
You can change the seat height by either raising or lowering the
four seat towers.
To change the seat height:
1. Remove the seat. See IV. “Disassembly.”
2. Remove the ball detent pin from each seat tower. See figure 11.
NOTE: Before you can remove the ball detent pin from each
front seat tower, you must first remove the front battery box.
See IV. “Disassembly.”
3. Raise or lower each seat tower to the desired position.
4. Install the ball detent pin into each seat tower.
5. Reinstall the seat.
To change the seat height:
You can change the seat angle by either raising or lowering only
one set of seat towers (front or rear).

ARMREST WIDTH

To change the armrest width:
1. Locate the two knobs on the armrest receiver bracket. See
figure 12.
2. Loosen the knobs and slide the armrests in or out to the
desired width.
3. Tighten the knobs.
UK Jazzy 1113/RevF/Apr03
A D J U S T M E N T S
BALL DETENT PIN
Figure 11. Seat Height Adjustment
Figure 12. Armrest Width Adjustment
www.pridemobility.com
ADJUSTMENT KNOB
21