Required Tools; Armrest Width - Pride Mobility Jazzy 1120 Owner's Manual

V . C O M F O R T
Once you are familiar with your Jazzy’s operation, you may find the need to adjust your seating position. There are
some adjustments you can make to increase your comfort, such as seat height and angle, armrest width and angle,
joystick position, and footrest height and angle.

Required Tools:

7/16-in. wrench, 5/32-in. hex key
CAUTION! If your Jazzy 1120 was configured at your authorized Pride provider, please consult your
health care professional before changing the seat position or before making any other adjustment.
Some adjustments may degrade your Jazzy’s performance and safety by changing its center of
gravity.
SEAT HEIGHT AND ANGLE
You can change the seat height by one of two ways: manually or
automatically. (If equipped with the optional Power Elevating Seat,
see “Power Elevating Seat Option” later in this section.)
To change the seat height:
1. Remove the seat. See VI. “Disassembly.”
2. Remove the shroud.
3. Remove the ball detent pin from each seat tower. See figure 16.
4. Raise or lower each seat tower to the desired position.
5. Install the ball detent pin into each seat tower.
6. Reinstall the shroud.
7. Install the seat.
You can change the seat angle by either raising or lowering only
one set of seat towers (front or rear).

ARMREST WIDTH

To change the armrest width:
1. Locate the two knobs on the armrest receiver bracket. See
figure 17.
2. Loosen the knobs and slide the armrests in or out to the desired
width.
3. Tighten the knobs.
Jazzy 1120
A D J U S T M E N T S
Figure 16. Seat Tower
LOOSEN KNOBS TO
MOVE ARMREST
Figure 17. Armrest Width
BALL DETENT PIN
15