Speed Settings - Pride Mobility Jazzy 1110 Owner's Manual

NOTE: If you still get “ripple up and down of lights”, contact your authorised Pride Dealer.
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash,
reminding you the batteries need to be charged immediately!

Speed Settings

The Remote Plus speed settings range from 1 to 5. Typically, the slowest speed setting is 1 and the fastest speed
setting is 5. The settings are indicated by the number of lights that are lit.
NOTE: The speed settings are preset at the factory. If your authorised Pride Dealer changes the order of
these settings, please make note of these changes. Contact your authorised Pride Dealer for more
information.
To select a speed setting:
1. Press the on/off key to power on the remote.
2. Press the mode key once.
3. To increase chair speed, push the joystick to the right. Each time you push the joystick, you will increase the
speed setting.
4. To decrease chair speed, push the joystick to the left. Each time you push the joystick, you decrease the speed
setting.
5. Once you select the desired speed setting, press the mode key once to keep the setting or push the joystick in
the forward or reverse direction. The chair will resume operation at the selected speed.
NOTE: We recommend that the first few times you operate your power chair, you have your speed on the
slowest setting until you become familiar with your new power chair.
Power Accessories
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can
operate them through the remote keypad. Contact your authorised Pride Dealer for information on how to operate
these accessories.
Off-board Charger/Programming Socket
You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on the
front of the controller. See figure 29. The socket may also be used for reprogramming the controller by using a
Penny & Giles Programmer, should this be necessary. If you use an off-board charger, the charger current should
not exceed 12 amps. Contact your authorised Pride Dealer for more information.
CAUTION! Only chargers with Neutrik NC3MX plugs should be connected to the off-board
charger/programming socket. See your authorised Pride Dealer for more information.
Controller Communications Cable
The controller communications cable provides the joystick module with a connection to the power module at the
back of the power base. See figure 29.
34
V I I . O P E R A T I O N
www.pridemobility.com UK Jazzy 1113/RevF/Apr03