Pride Mobility Jazzy 1110 Owner's Manual page 39

Sleep Mode (If Enabled)
The power chair controller features a sleep mode. Sleep mode is a built-in circuit that will automatically shut off the main power
if the joystick is not moved in any direction for a period of time. This time factor is programmed into the controller. To restore
power and continue, push the on/off key on the keypad.
Trouble Codes
The system status light is displayed within the on/off key. This light is lit if the system is turned on. It also flashes in groups called
flash codes, to indicate system faults. The table below identifies the individual fault codes. If your keypad displays one of these
codes, contact your authorised Pride Dealer.
FLASH CODE
SEQUENCE
•—•—•—
••—••—••—
•••—•••—
••••—••••—
•••••—•••••—
••••••—••••••—
•••••••—•••••••—
•••••••—•••••••—
•••••••—•••••••—
•••••••—•••••••—
•••••••—•••••••—
•••••••—•••••••—
NOTE: You must turn the controller off and then on again to reset the controller, even if the source of the fault is
removed/corrected.
In the event of a fault, the system status light displays diagnostic indications. Faults are encoded as follows: one (for a low battery
voltage fault) to twelve (module mismatch) and are displayed by the light flashing the number of times prescribed by the fault
code. The flash sequence (one to twelve) is followed by a long off period (2 seconds). If more than one fault exists, then the fault
having the highest priority is indicated. The controller must be turned off and then on again even if the source of the fault is
removed. If you cannot resolve the problem, contact your authorised Pride Dealer.
UK Jazzy 1113/RevF/Apr03
V I I . O P E R A T I O N
DIAGNOSIS
DX module fault
DX accessory fault
Left motor (or connection) fault
Right motor (or connection) fault
Left park brake fault
Right park brake fault
Low battery fault
Over voltage fault
CANL fault
CANA fault
Stall timeout
Module mismatch
See your authorised Pride dealer.
See your authorised Pride Dealer.
Check left motor wiring.
Check right motor wiring.
Check motor/brake wiring.
Check motor/brake wiring.
Check that the battery wiring is secure.
Check that the battery wiring is secure.
See your authorised Pride Dealer.
See your authorised Pride Dealer.
Turn unit on, then off.
See your authorised Pride Dealer.
www.pridemobility.com
SOLUTION
39