Pride Mobility Jazzy 1110 Owner's Manual page 47

I X . C A R E
CAUTION! Direct exposure to water or dampness
could cause the power chair to malfunction elec-
tronically and mechanically. Water can cause
electrical components to corrode and the chair’s
frame to rust.
TYRES AND TUBES
If your Jazzy 1113 is equipped with pneumatic tyres, you should
check the air pressure at least once a week. This prolongs the life
of your tyres and helps to ensure the perfect operation of your
chair. If you have a flat tyre, replace the tube. Replacement tyres
and tubes are readily available through the dealer where you purchased
your Jazzy 1113.
WARNING! To avoid possible injury, be sure that
the controller’s power is turned off and the power
chair is not in freewheel mode before performing
this procedure.
WARNING! Completely deflate the tyre before at-
tempting repair.
Follow these easy steps for a quick and safe tube or
tyre replacement:
1. Completely deflate the tyre (if pneumatic).
2. Remove the nut from wheel axle. See figure 33.
3. Pull the wheel off of the axle.
4. Separate the tyre and tube from the wheel.
5. Remove the old tube and/or tyre and replace with new tube or
tyre.
6. Slide the wheel back onto the shaft and torque the nut to 16
ft.-lbs.
7. Inflate the tyre to 2 - 2.4 bar (30 - 35 psi) (if pneumatic).
UK Jazzy 1113/RevF/Apr03
A N D M A I N T E N A N C E
www.pridemobility.com
REMOVE THIS
NUT & WASHER TO REMOVE WHEEL
Figure 33. Drive Wheel
Figure 34. Disconnecting Battery Box
Connections
Figure 35. Battery Box Removal
47