Seating System; Seat Height; Armrest Width And Height; Armrest Angle - Pride Mobility JET 3 Owner's Manual

Seating System

After you have used your Jet 3 for an extended period of time, you may
find the need to make some adjustments to increase your comfort.
WARNING! If your Jet 3 was configured by your
authorised Pride provider, please consult them be-
fore making any adjustments. Some adjustments
may degrade your Jet 3's performance and safety
by changing its center of gravity.

SEAT HEIGHT

You can change the seat height to one of five positions in 2.5 cm
increments.
To change the seat height:
1. Remove the seat and the shroud.
2. Use a 14-mm spanner to loosen and remove the hex-head nut
and bolt. See figure 14.
3. Loosen the seat post base locking nut using an 11-mm
spanner and a 5-mm hex key.
4. Slide the seat pedestal up or down in the seat post base.
5. Align the holes on the seat post and the seat post base.
6. Reinstall and tighten the hex-head nut and bolt.
7. Retighten the seat post base locking nut.

ARMREST WIDTH AND HEIGHT

To change the armrest width:
1. Locate the setscrew on the armrest receiver bracket.
See figure 15.
2. Loosen the setscrew, and slide the armrest in or out to the
desired width.
3. Retighten the setscrew.
4. Repeat for the other armrest.
To change the armrest height:
1. Loosen the armrest adjustment height setscrew located
underneath the armrest. See figure 15.
2. Raise or lower the armrest as desired.
3. Retighten the setscrew.
4. Repeat for the other armrest.

ARMREST ANGLE

You can adjust the armrest angle to fit your specific needs.
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Use an 11-mm spanner to loosen the locking nut. See figure 16.
3. Use an 11-mm spanner to loosen the adjusting screw. Turn the
screw clockwise to raise the front of the armrest and
anticlockwise to lower the front of the armrest.
4. Lock the adjusting screw into place by tightening the locking nut.
14
JET 3
PRIDE MOBILITY PRODUCTS AUSTRALIA PTY. LTD - INFMANU1568 REV B OCT 2002
SEAT POST
SEAT PEDESTAL
SEAT POST
BASE LOCKING
NUT
HEX-HEAD
NUT AND
BOLT
SEAT POST
BASE
Figure 14. Seat Height Adjustment
LOOSEN
SETSCREW TO
ADJUST
ARMREST
HEIGHT
ARMREST
RECEIVER
BRACKET
LOOSEN SETSCREW
TO ADJUST ARM-
REST WIDTH
Figure 15. Armrest Width/Height Adjustment
LOCKING
NUT
ADJUSTING
SCREW
Figure 16. Armrest Angle