Table of Contents
Advertisement
V I .
C O M F O R T
Once you are familiar with your Jazzy’s operation, you may find the need
to adjust your seating position. There are some adjustments you can make
to increase your comfort, such as seat height and angle, armrest width,
angle and height, joystick position, and footrest height, depth and angle.
CAUTION! If your Jazzy was configured at your lo-
cal Pride provider or service center, please consult
your health care professional before changing the
seat position or making any other adjustment. Some
adjustments may degrade your Jazzy’s performance
and safety by changing its center of gravity.
SEAT HEIGHT AND ANGLE
You can change the seat height by one of two ways: either manually or
automatically. (If equipped with the optional Power Elevating Seat, see
“Power Elevating Seat Option” later in this section.)
To change the seat height:
1. Remove the seat. See VII. “Disassembly.”
2. Remove the foot frame.
3. Remove intermediate shroud by releasing two 1/4 turn fasteners.
4. Remove the ball detent pin from each seat tower. See figure 14.
5. Raise or lower each seat tower to the desired position.
6. Install the ball detent pin into each seat tower.
7. Reinstall intermediate shroud and foot frame.
8. Install the seat.
To change the seat angle:
1. Remove the seat hinge bolt with a 5/32-in. hex key and a 7/16-in.
wrench. See figure 15.
2. Adjust seatback to desired angle and reinsert the seat hinge bolt.
3. Tighten bolts with the hex key and wrench.
ARMREST WIDTH
To change the armrest width:
1. Locate the two knobs on the armrest receiver bracket. See figure 16.
2. Loosen the knobs.
3. Slide the armrests in or out, to the desired width.
4. Tighten the knobs.
18
All manuals and user guides at all-guides.com
A D J U S T M E N T S
SEAT
BALL DETENT
TOWER
Figure 14. Seat Height
SEAT
HINGE
BOLT
Figure 15. Seat Angle
ADJUSTMENT KNOBS
Figure 16. Armrest Width
JAM NUT
SCREW
Figure 17. Armrest Angle
Jazzy 1120
2000
Advertisement
Table of Contents
