Step 2 - Initial Camera Settings - Ikelite 6146.02 Instruction Manual

STEP 2 - Initial Camera Settings

Setup your camera for underwater use and then adjust your settings once underwater.
Initial Camera Setup
- Insert a fully charged camera battery.
- Set Mode Dial to "Av" Aperture Priority, or "M" Manual Mode if shutter
speeds faster than 1/60th second are required.
In MENU:
-
Set AF Frame to "1-point" and Digital Zoom to "Off."
Set AF-Point Zoom to "Off" and Set Servo AF to "On."
Set Continuous AF to "Off" and AF-assist Beam to "Off."
In the Flash Control Built-in Flash Settings Menu, set Flash Mode to
"Auto", Shutter Sync. to "1st-curtain", Red-eye Corr. and Red-eye Lamp
to "Off."
Set Review Image after Shooting to "8 sec." and Display Info to "Off."
Set Blink Detection and Night Display to "Off."
In MENU:
-
Set Date/Time and Time Zone.
Set Eco Mode to "Off."
In the Power Saving Menu, set Auto Power Down to "Off" and Display
Off to "3 min."
Set Touch Operation to "Off."
Insert and Format a compatible memory card.
In FUNC./SET MENU:
-
Set DR Correction to "Off" and White Balance to "Auto" or "Underwater."
For best results, use manual
each working depth.
Set Drive Mode to "Single Shot
Set Metering to "Center Weighted Avg.
Set ND Filter to "Off."
8
(before placing camera in housing)
Custom White Balance and reset for
."
"