Step 6 - Attach The Step Ring Gear - Ikelite 6146.02 Instruction Manual

STEP 6 - Attach the Step Ring Gear

The supplied Step Ring Gear is attached to the camera control ring by 3
small nylon Allen Set Screws. Place the Control Ring Gear over the
camera's step ring before installing the camera in the housing. The gear
is a "press fit" over the lens. Gently tighten all three allen screws with
the supplied Allen Wrench as show in the Diagram below. DO NOT
overtighten or you may damage the gear, or cause it to warp and bow
out from the lens Step Ring. Make sure to test it's function once
installed.
When installing the camera in the housing, make sure that the Step Ring
Gear meshes properly with the smaller black housing gear.
When removing the Gear, leave the Set Screws in the Gear. The Set
Screws are very small and easy to lose. Extra Set Screws are included
with your housing. We recommend that you leave the gear installed as it
makes rotating the camera control ring easier when out of the housing.
Set Screw
12
Turn clockwise to tighten. DO NOT overtighten
or you may warp or damage the gear.
Step Ring Gear
(properly installed)
Allen
Wrench