Step 9 - Final Check; Usage; Strobe Use And Compatibility; Strobe Compatibility - Ikelite 6146.02 Instruction Manual

STEP 9 - Final Check

The clear housing permits instant visual inspection of the camera and
sealing surfaces as well as complete monitoring of controls and camera
LCD screens. This housing has been factory water pressure tested to
200 ft (60 m).
Once the housing is closed, recheck the o-ring seal. Double check the
gap between the housing back and the housing. It should be even all the
way around the housing.
Look through the clear plastic back at the o-ring. You should see a
darkened area or solid black line where the o-ring is compressed against
the housing back. If you do not see an even black compression seal all
the way around the back, open the lid snaps, reseat the housing back and
close the lid snaps. Visually check the seal again.

Usage

Turn the camera on and operate each of the housing controls to assure
proper functioning. Take a few test shots on land. Make sure the Flash
Diffuser is installed when using only the built-in camera flash, or install
the Flash Deflector when using external strobes, Page 17.

Strobe Use and Compatibility

Always install the Flash Deflector when using external strobes.

Strobe Compatibility

- AF35 ........................no
- DS50........................yes, above serial number 70,000
- DS51........................yes
- DS125......................yes, above serial number 5000
- DS160, DS161 ........yes
- DS200......................yes
- Non-Ikelite ..............yes, manual flash exposure only
14