Yamaha Digital Sound Projector YSP-4300 Owner's Manual page 92

FCC INFORMATION (for US customers)
1. 1 IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions
contained in this manual, meets FCC requirements.
Modifications not expressly approved by Yamaha may void your
authority, granted by the FCC, to use the product.
2. IMPORTANT: When connecting this product to accessories
and/or another product use only high quality shielded cables.
Cable/s supplied with this product MUST be used. Follow all
installation instructions. Failure to t_llow instructions could
void your FCC authorization to use this product in the USA.
3. NOTE: This product has been tested and found to comply with
the requirements listed in FCC Regulations, Part 15 for Class
"B" digital devices. Compliance with these requirements
provides a reasonable level of assurance that your use of this
product in a residential environment will not result in harmfid
interference with other electronic devices.
This equipment generates/uses radio frequencies and, if not
installed and used according to the instructions t_und in the
users manual, may cause interference harmfid to the operation
of other electronic devices.
Compliance with FCC regulations does not guarantee that
interference will not occur in all installations. If this product is
found to be the source of interference, which can be determined
by turning the unit "OFF" and "ON", please try to eliminate the
problem by using one of the following measures:
Relocate either this product or the device that is being affected
by the interference.
Utilize power outlets that are on different branch (circuit breaker
or fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the
antenna. If the antenna lead-in is 300 ohm ribbon lead, change
the lead-in to coaxial type cable.
If these corrective measures do not produce satisfactory results,
please contact the local retailer authorized to distribute this type
of product. If yon can not locate the appropriate retailer, please
contact Yamaha Corporation of America A/V Division, 6600
Orangethorpe Ave., Buena Park, CA 90620.
The above statements apply ONLY to those products distributed
by Yamaha Corporation of America or its subsidiaries.
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s).
Operation is subject to the t_llowing two conditions: 1) this device may not cause harmfid interference, and 2) this device must accept any
interference received including interference that may cause undesired operation.
See the "Troubleshooting" section on the Owner's manual if interference to radio reception is suspected.
FCC WARNING
Change or modifications not expressly approved by tile party responsible for compliance could void tile user's authority to operate tile eqnipment.
NOTICE
This equipment has been tested and t_und to comply with the limits t_r a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in aresidential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmfid interference to radio communications. However. there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmfid interference to radio or television reception, which can be determined by turning the equipment oft" and on, the
user is encouraged to try to correct the interference by one or more of the t_llowing measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment compiles with FCC/IC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF)
Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels
of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it shoukt be installed and
operated with at least 20 cm and more between the radiator and person's body (excluding extremities: hands, wrists, feet and ankles).
This transmitter must not be co-located or operated in con innction with any other antenna or transmitter.
The name plate is located on the bottom of the unit.
YSP-CU4300
YSP-CU3300
(Examples of the name plate)
FOR CANADIAN CUSTOMERS
To pre_.ent electric shock, match wide blade of plug to wide slot
and Sully insert.
This Class B digital apparatus complies with Canadian ICES-003.
POUR LES CLIENTS RI_SIDANT AU CANADA
Afin d'&,iter les risqnes de ddcharges dlectriqnes, _.eillez "t insdrer
_ fond la large broche de la fiche dans la large fente de la prise de
conralLt.
Cet appareil nnmdrique de Classe B est conforme _ la norme
canadienne ICES-003.
IMPORTANT
Please record the serial number of this unit in the space below.
MODEL:
Serial No.:
The serial number is located on the bottom of the unit.
Retain the Owner's Manual in a sate place for flmLre reference.
This unit may affect radio waves of iPhone when iPhone is
charged by using this unit. In addition, radio waves of this unit
and iPhone may interfere with each other. If yon have a problem
with your telephone call, disconnect your iPhone from this unit.
(YSP-CU4300 only)
2 En