Auto Setup (Intellibeam) - Yamaha Digital Sound Projector YSP-4300 Owner's Manual

Initial settings
At'it
SETUP
Fiiiiiiiiiiiiiiiiiiiiiiiiiiiill
ENTER
RETURN
AUTO SETUP via setup menu
1 Place the IntelliBeam microphone at you r
normal listening position, and press the
SETUP key.
See "Installing the [ntelliBeam microphone" (,_xp. 23) for
instructions on positioning the IntelliBeam microphone.
Select Item:
"BEAM+SOUND OPTIMIZE"
(Beam optimization and sound optimization)
Select this optimization feature if you make settings for the
first time. This menu takes about 3 minutes.
"BEAM OPTIMIZE ONLY"
(Beam optimization only)
Use to optimize the beam angle so that the parameter best
matches your listening environment. This menu takes about
1 minute.
"SOUND OPTIMIZE ONLY"
(Sound optimization only)
Use to optimize the beam delay, volume, and quality so that
the paraineters best match your listening environment. This
menu takes about 2 minutes.
You must optimize the beam angle with "BEAM
OPTIM[ZE ONLY" before starting "SOUND OPTIM[ZE
ONLY". Select this optimization feature in the following
cases:
• If you have opened or closed the curtains in your
listening room before using this unit
• If you have manually set the beam angle.
(PREPARATION & CHECK)" screen is ......
displayed. .........
For the details on connecting [ntelliBeam microphone,
refer to 'Using AUTO SETUP (IntelliBeam)" (_,:'p. 24).
Follow steps 4, and 6 under :fUsing
AUTO SETUP (IntelliBeam)' to configure
settings, and then remove the microphone.
The ENTER key,
performs
lhe same function as lhe • key.
26
En