Table of Contents
Advertisement
1.0
INTRODUCTION
This manual describes how to connect the USB930HxADBD daughter card to the 8x930 Family
USB Evaluation Board Rev B. The 8x930Hx chip supports one upstream USB port and four
downstream USB ports.
Due to pin incompatibilities, this daughter card can be used with the four-port
8x930 Family USB Evaluation Board Rev B only.
2.0
INSTALLATION
2.1
Installing the Adapter Board
1.
Remove the 8x930Ax device installed on the 8x930 Family USB Evaluation Board Rev B
from the U3 socket prior to installing the adapter board. Refer to
of socket U3
2.
Place the adapter on the evaluation board, ensuring that the connectors are properly
aligned, and press the adapter onto the evaluation board until the connectors are fully
engaged. Refer to
NOTE
Figure 2
for the correct orientation for the adapter board.
Figure 1
for the location
1
Advertisement
Table of Contents
