Fan
Description
Fan
The fan is located under the heat sink. It is secured with four Torx screws.
To remove the fan assembly:
1.
Prepare the computer for disassembly (see
2.
Remove the access panel (see
3.
Remove the heat sink (see
4.
Disconnect the fan cable from the system board connector labeled CHFAN (1).
5.
Remove the four Torx screws that secure the fan to the computer (2).
6.
Remove the fan from the computer.
To install the fan assembly, reverse the removal procedures.
NOTE:
To avoid damaging the rubber screw grommets installed around the captive screws, when
installing the fan, push down on the fan assembly before you tighten the screws. Make sure the
grommets are positioned correctly before tightening the screws.
46
Chapter 5 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Access panel on page
Heat sink on page
43).
26).
Spare part number
768424-001
25).