External Connection Antennas (Select Models Only) - HP EliteDesk 800 G1 Maintenance & Service Manual

External connection antennas (select models only)

The external connection antennas route from the WLAN module to the cable connectors on the rear of
the computer.
To install the antennas:
1.
Prepare the computer for disassembly (see
2.
Remove the access panel (see
3.
Remove the hard drive (see
4.
Remove the drive cage (see
5.
Remove the heat sink (see
6.
Remove the fan (see
7. Using a screwdriver, pry out the two knockouts that cover the antenna cable connector holes on
the back of the computer.
Preparing to disassemble the computer on page
Access panel on page
Hard drive on page
Drive cage on page
Heat sink on page
Fan on page 46).
External connection antennas (select models only)
26).
28).
47).
43).
25).
53