HP EliteDesk 800 G1 Maintenance & Service Manual page 83

●
●
●
●
●
BIOS Power-On
Allows you to set the computer to turn on automatically at a time you specify.
Onboard Devices Allows you to set resources for or disable Legacy devices.
Select the Legacy device's IRQ, DMA, and I/O Range. The settings may not take effect for all
operating systems. To hide a device from the operating system, see Security > Device Security.
Bus Options
Allows you to enable or disable:
●
●
Device Options
Allows you to set:
●
●
●
●
●
●
POST Delay (in seconds). Enabling this feature will add a user-specified delay to the POST
process. This delay is sometimes needed for hard disks on some PCI cards that spin up very
slowly, so slowly that they are not ready to boot by the time POST is finished. The POST delay
also gives you more time to select
Remote Wakeup Boot Source (remote server/local hard drive). Default is Local hard drive.
Factory Recovery Boot Support (Enable/Disable). Provides the ability for the BIOS to redirect
the boot to the recovery partition on the user hard drive, if present. Some versions of the
recovery software honor the
Default is disabled.
Bypass F1 Prompt on Configuration Changes (Enable/Disable). Allows you to set the computer
not to confirm when changes were made. Default is disabled.
POST Memory Manager Runtime Allocation (Enable/Disable). Default is disabled.
PCI SERR# Generation. Default is enabled.
PCI VGA Palette Snooping, which sets the VGA palette snooping bit in PCI configuration
space; only needed when more than one graphics controller is installed. Default is disabled.
Num Lock State at Power-On (off/on). Default is off.
Internal Speaker (does not affect external speakers). Default is enabled.
Multi-Processor (enable/disable). Use this option to disable multi-processor support under the
OS. Default is enabled.
USB Charging Port (enable/disable). Default is enabled.
USB 3.0 BIOS Driver Support (enabled/disabled). Default is disabled.
Hyper threading (enable/disable). Use this option to disable processor hyper-threading.
F10 to enter Computer (F10) Setup. Default is None.
F11 key press even when this feature is disabled by the BIOS.
Computer Setup (F10) Utilities
75