Installing Sodimms - HP EliteDesk 800 G1 Maintenance & Service Manual

Installing SODIMMs

CAUTION:
to drain before adding or removing memory modules. Regardless of the power-on state, voltage is
always supplied to the memory modules as long as the computer is plugged into an active AC outlet.
Adding or removing memory modules while voltage is present may cause irreparable damage to the
memory modules or system board.
The memory module sockets have gold-plated metal contacts. When upgrading the memory, it is
important to use memory modules with gold-plated metal contacts to prevent corrosion and/or
oxidation resulting from having incompatible metals in contact with each other.
Static electricity can damage the electronic components of the computer or optional cards. Before
beginning these procedures, ensure that you are discharged of static electricity by briefly touching a
grounded metal object. For more information, refer to
When handling a memory module, be careful not to touch any of the contacts. Doing so may damage
the module.
1.
Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Disconnect the hard drive power cable (1) and data cable (2) from the system board.
WARNING!
components to cool before touching.
You must disconnect the power cord and wait approximately 30 seconds for the power
Access panel on page
To reduce risk of personal injury from hot surfaces, allow the internal system
Electrostatic discharge information on page
Preparing to disassemble the computer on page
26).
9.
25).
Memory
37