Solving Memory Problems - HP EliteDesk 800 G1 Maintenance & Service Manual

Network controller stops working without apparent cause.
Cause
The files containing the network drivers are corrupted.
The cable is not securely connected.
The network controller is defective.
New network card will not boot.
Cause
New network card may be defective or may not meet industry-
standard specifications.
Cannot connect to network server when attempting Remote System Installation.
Cause
The network controller is not configured properly.
System setup utility reports unprogrammed EEPROM.
Cause
Unprogrammed EEPROM.

Solving Memory Problems

If you encounter memory problems, some common causes and solutions are listed in the following
table.
CAUTION:
the Management Engine (ME) settings). To avoid damage to the DIMMs or the system board, you must
unplug the computer power cord before attempting to reseat, install, or remove a memory module.
For those systems that support ECC memory, HP does not support mixing ECC and non-ECC memory.
Otherwise, the computer will not boot the operating system.
Power may still be supplied to the DIMMs when the computer is turned off (depending on
Solution
Reinstall the network drivers using the Recovery Disc Set in
Windows 7 or Windows recovery tools in Windows 8.
If necessary, download the softpaq from the web (from a
different computer).
Ensure that the cable is securely attached to the network
connector and that the other end of the cable is securely
attached to the correct device.
Contact an authorized service provider.
Solution
Install a working, industry-standard NIC, or change the boot
sequence to boot from another source.
Solution
Verify Network Connectivity, that a DHCP Server is present,
and that the Remote System Installation Server contains the
NIC drivers for your NIC.
Solution
Contact an authorized service provider.
Solving Memory Problems
111