Standard Installation Layout - Chamberlain CSW200UL8 Owner's Manual

INSTALLATION

STANDARD INSTALLATION LAYOUT

Sample of standard arm attachment is shown on previous page.
1/4
Mount bracket at least a quarter of the gate length from the gate hinge.
NOTE: Longer gates or retro-fits may require both arms to be lengthened by equal parts.
Drawing not to scale
Helpful Layout Note:
A) Long arm's final placement is on TOP of
bracket.
B) Tack weld bracket in position.
C) Close gate, place tape measure between
bracket and output shaft.
D) With tape between bracket and output shaft,
open gate and bend tape until tape is 90°
from gate.
E) Take measurements of arms from bend in
tape measure.
Arm must be 90° from Gate
DO NOT allow arms to
scissor when open.
Top View of Closed Gate
1/4
Bracket Position
Gate Open 90°
8" Minimum to avoid
Long arm
is on TOP
of
bracket.
11
1/4
Bracket Length
Gate Hinge Center
Top View of Operator in Open Position
10"
9" Minimum
for Gate
Clearance
scissoring of arms
Concrete Pad
24"
IMPORTANT NOTE:
If this dimension is between
20 and 32 inches, "Compact
Installation" is necessary.
(Refer to next page.)
Gate Hinge
28"
Output Shaft Center
Short Arm
Long Arm
For technical support: 1-800-528-2806