Joyner TROOPER T2 Owner's Manual page 87

conditions, and if there are any damages in
outer appearance.
5.4. Assembling
5.4.1. Smear lubricating oil on the new oil
seal lip section.
Install the oil seal shown as the right
5.4.2.
figure.
6. Assembling
6.1. Assembling of the oil sealing stands
Smear oil sealing silica on the oil sealing
stands shown as the right figure.
[Grease] Letai 5699
Attention The liquid sealing silica is to be
smeared to the mating section of the oil seal
stands and cylinder body surface, with a
width of 3—4mm.
[Torque] 25±1.5N.m
6.2. Assembling of new oil pump washer, oil
pump assembly
[Torque] 20±1.5N.m
6.3. Installation of new lubricating oil collecting and
filtering device, oil pump collecting and filtering
device
[Torque] 6±1N.m
6.4. Assembling of oil pan
Oil sealing lip
SST
SST
87
Seal line