Joyner TROOPER T2 Owner's Manual page 85

should be no visible tears, wears and
scrapes on the pressure relief valve
4.4. Installation
After smearing lubricating oil on the lips of
4.4.1.
the new T-shaped oil seals, use SST to
make the assembly.
Attention
·Use new oil seal..
·The exposed part of the outer edge of the oil
seal after being pressed in should be less than
0.5mm.
4.4.2. Assembling of the oil pump pressure relief
valve and split pins
Attention The split pins are not reusable.
4.4.3. The marks of the exterior and interior
gears of the lubricating oil pump should be
on the visible side when being assembled
into the pump body.
4.4.4. The new weather seal should be put
inside the oil pump cover groove.
85
Mark