Normal Operation; General - Takagi T-KJr2U-IN Installation Manual And Owner's Manual

NORMAL OPERATION

The illustration below shows an example of the display. The exact display may differ from examples.
"INFO" Button
Each time the button is pressed,
the operation mode is selected
in the sequence of the following.
Inlet water
Outlet water
temperature
temperature
IN USE LED (Green)
The lamp lights during combustion.
STAND BY LED (Orange)
The indicator is ON to show that
power is ON.
Temperature above 125 °F (52 °C) can cause severe burns or death from scalding.
Children, disabled and the elderly are at high risk of being injured.
CAUTION
1. Open a hot water tap. 2. Mix cold water with the hot to get
NOTICE
• Flow rate to activate the water heater: 0.5 gallon per minute at the default set
temperature (2.0 L/min).
• Flow rate to keep the water heater running: 0.4 gallon per minute (1.5 L/min).
The remote controller has an energy saving mode. Five minutes after the water
heater stops operating, the backlight of the remote controller turns off.
The backlight of the remote will turn back on once the water heater begins firing
again.
REMOTE CONTROLLER
Water
flow

GENERAL

the correct temperature water.
36
Display for Temperature
When the stand by LED is ON, the
hot water temperature will be
displayed.
"COLD" Button
"HOT" Button
Press the "HOT" button or the
"COLD" button to set the hot
water temperature.
"ON/OFF" Button
Press this button to
start or stop operation.
3. Close the hot water tap.
Page
Owner's Guide
Normal Operation