Takagi T-KJr2U-IN Installation Manual And Owner's Manual page 23

3. Tighten the two "Fork terminals" beneath the two "Remote controller terminal" screws on
the back of the main body. (Fig. C-1)
4. Cut out the inlet for the remote controller cable from the bottom of the main body. (Fig. C-2)
5. Place the "Main body" back on the "Back plate", with the "Remote controller cable" running
out of the bottom inlet.
6. Connect the "Remote controller cable" to the remote controller terminal on the computer
board. See p.22 for details.
Inlet for the remote
controller cable
<How to connect the remote controller to the water heater>
1. Disconnect power supply from
the water heater.
2. Take off the water heater's front
cover.
3. Locate the remote controller
terminal, pictured to the right
(located around the lower right-
hand side of the computer
board).
4. Open the plastic cover of the
remote controller, and then
attach the two fork terminals to
connector base of the backside
the remote controller with two
screws. Make sure the terminals
are firmly fixed.
Fig. C-2
Cut out
110U (T-KJr2U) and 310U (T-K4U) models
Connect other end to these terminals
23
Fig. C-1
Remote controller
terminals
Remote controller cable
Page
Two fork terminals
9008172005
(TM-RE40)
Front of remote