Table of Contents
Advertisement
Installation
Serial Port Settings
The
(COM1 and COM2) icons represent the
serial ports of the video network station. Use these
icons when an EVI-D30/D31/G20/G21 or HSR-1/1P/
2/2P is connected to the "COM1" or "COM2" ports to
set up serial port function and communications
parameters.
Note
If a serial port has the Click "Save" icon enabled, the
video network station reboots and alarm memory
contents are erased, so check the alarm memory
contents, if necessary, before setting.
1
Click the "COM1" (or "COM2") icon.
The screen displays the "Serial Port 1 Settings" (or
"Serial Port 2 Settings").
2
Make the required settings. Available settings are
as follows.
Setting
Options
Purpose
Pan Tilt
HSR (only
displayed for
COM1)
18
Description
Select this if an EVI-D30/
D31/G20/G21 is connected to
the port.
When selected, the "Pan Tilt"
icon shown below is added
next to the "COM1" or
"COM2" icon.
Select this if an HSR-1/1P/2/
2P is connected to the port.
When selected, the "HSR"
icon shown below is added
next to the "COM1" icon.
Setting
Options
Purpose
Modem
(only
displayed for
COM2)
None
Serial
Select the appropriate interface type:
Mode
[RS232] for the EVI-D30/D31/G20/G21 and
(only
HSR-1/1P/2/2P.
displayed
for
COM1)
Baud
Select the transfer speed: Select [9600] for
Rate
the EVI-D30/D31/G20/G21, or [1200] to
(bps)
[38400] as the HSR setting to match that of
the HSR-1/1P/2/2P.
Data Bits
Select [8] data bits for the EVI-D30/D31/
(length)
G20/G21 and HSR-1/1P/2/2P.
Stop Bits
Select [1] stop bit for the EVI-D30/D31/G20/
G21 and HSR-1/1P/2/2P.
Parity Bit
Select [None] for the EVI-D30/D31/G20/
G21 and HSR-1/1P/2/2P.
3
Click the "Save" icon when finished with the
settings.
The new settings are saved, the video network
station reboots, and the display changes as follows
depending on the selected usage.
• When [Pan Tilt] is selected, the "Pan Tilt
Settings" page appears. Refer to "Pan/Tilt Driver
and Video Camera ID Setup" below.
• When [HSR] is selected, the "Sony HSR
Settings" page appears. Refer to "HSR-1/1P/2/2P
Setup" on page 20.
• When "Modem" is selected, the "Modem
Settings" page appears. Refer to "Modem Setup"
on page 22. Also, to set up dial-up connection via
modem, refer to "ISP (Internet Service Provider)
Setup" on page 22.
Description
Select this if a modem is
connected to the port.
When selected, the "Modem"
and "ISP" icons shown below
are displayed.
Select this if no device is
connected to a port.
Advertisement
Table of Contents
