7000-SERIES MULTI-AMP CONFIGURATION GUIDE
4.9
Verify and Adjust Amplifier Gain
1.
On the main board of each amplifier, locate the Amp Gain Trim (R210) (see Figure 4.10).
2.
Connect a digital voltmeter set to AC volts between the OUTPUT and COM terminals of the first amplifier.
See Figure 4.14.
3.
Power up the first amplifier.
4.
Apply a sine wave to the amplifier input of approximately 5Vrms (100-500 Hz). This should result in
about 100Vrms output from the amplifier (assuming a fixed gain of 20).
5.
If voltmeter indicates an output greater or lesser than 100 Vrms, adjust Amp Gain Trim (R210) to correct.
6.
Power up and repeat this procedure for the second amplifier and all other amplifiers in your system.
22
Figure 4.14– Wiring and Test Points for Amp Gain
Information subject to change
97-8002465_06-09-14