Troubleshooting - DTS 412 Installation Manual

SYMPTOMS
When pressing the remote
transmitter the gate operator
will not respond at all
Or
PCB responds but gate will
not open
When pressing either the
transmitter or the PCB
button or the hardwire
button on the wall, the gate
opens +- half a metre and
stops.

TROUBLESHOOTING

CAUSES
Transmitter battery flat.
Transmitter physically
damaged.
Transmitter has not been
programmed into the receiver
memory.
Condominium /loop option is
not activated and the battery
has reached its low level
(10/20 Volt) Indicated by 3
beeps / 3 beeps.
The transmitter is being
pressed and held.
The button input is being
pressed and held.
The button is jamming in the
N/C position or has been wired
normally closed.
The opposite limit switch is
jamming N/C or has been
wired up N/C.
12
ACTION
Replace transmitter battery.
Check with supplier.
Follow the receiver setup
instructions.
Check the household main
supply, the transformer or PSU
and all related cabling.
Press and release the
transmitter button to operate
the gate.
Press and release the button to
operate the gate.
Replace the button or rewire
the equipment.
Replace the switch, rewire
correctly or check limit spring
assembly.