Louvre Removal; Window Frame Assembly Removal; Glass Cleaning; Glass Information - Majestic 33LDVR Installation Instructions And Homeowner's Manual

Builder rear vent direct vent
Table of Contents

Advertisement

LDVR Series Direct Vent Gas Fireplace

Glass Information

Only glass approved by Vermont Castings
Group should be used on this fireplace.
The use of any non-approved replacement glass will
void all product warranties.
Care must be taken to avoid breakage of the glass.
Do not operate appliance with glass front removed,
cracked or broken.
Replacement glass (complete with frame window)
is available through your Vermont Castings Group
dealer and should only be installed by a licensed
qualified service person.

Louvre Removal

The top louvre panel is
removed by lifting the
panel vertically and pulling
it away from the appliance.
(Fig. 41) The lower access
door is hinged along the
bottom edge and is folded
down to allow access.

Window Frame Assembly Removal

1. Turn the fireplace OFF (including the pilot)
. If the unit has been operating allow time for the
components to cool.
3. Remove the top louvre assembly.
4. Open the lower louvre panel.
5. Release the two clamps securing the lower edge of the
window frame assembly by pulling down on the handles.
(Fig. 4)
4
Operating Instructions
2.
Louvre
1.
Glass Panel
FP17
Fig. 41 Remove top louvre
assembly.
FP1227
Louvre removal
11/02
6. Tilt the window frame assembly out slightly at the
bottom, lift the window frame assembly up and away
from the fireplace.
7. To replace the window frame assembly reverse
the procedure.
Window
Frame
Assembly
Fig. 42 Window frame assembly removal.

Glass Cleaning

It is necessary to periodically clean glass. During start-
up condensation, which is normal, forms on the inside of
FP1228
the glass. This condensation causes lint, dust and other
remove glass frame
airborne particles to cling to glass surface.
11/02
Also initial paint curing may deposit a slight film on the
glass. It is therefore recommended the glass be cleaned
two or three times with a non-ammonia based household
cleaner and warm water (We recommend gas fireplace
glass cleaner) within the first few weeks of operation.
After the initial cleaning process the glass should be cleaned
two or three times during each operating season depending
on the environment in the house.
Clean glass after first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
Lower Clamps
Window
Frame
Assembly
Pull Clamp
Hook
Push
Clamp
Handle
FP18
10007317

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

36ldvr43ldvr39ldvr

Table of Contents