Table of Contents
Advertisement
Glass Information
Only glass approved by CFM Specialty
Home Products should be used on this
fireplace.
•
The use of any non-approved replacement glass will
void all product warranties.
•
Care must be taken to avoid breakage of the glass.
•
Do not operate appliance with glass front
removed, cracked or broken.
•
Replacement glass (complete with gasket) is
available through your CFM Specialty Home
Products dealer and should only be installed by
a licensed qualified service person.
Louvre Removal
The top louvre panel is
removed by lifting the
panel vertically and
pulling it away from the
appliance. (Fig. 36) The
lower access door is
hinged along the
bottom edge and is
folded down to allow
access.
Window Frame Assembly Removal
1. Turn the fireplace OFF (including the pilot)
2. If the unit has been operating allow time for the
components to cool.
3. Remove the top louvre assembly.
4. Open the lower louvre panel.
5. Release the two clamps securing the lower edge of
the window frame assembly by pulling down on the
handles. (Fig. 37)
6. Tilt the window frame assembly out slightly at the
bottom, lift the window frame assembly frame up
and away from the fireplace.
7. To replace the window frame assembly reverse
the procedure.
10003357
Operating Instructions
2.
Louvre
1.
Glass Panel
FP1227
Fig. 36 Remove top louvre
assembly.
BDVR Series Direct Vent Gas Fireplace
Window
Frame
Assembly
Fig. 37 Window frame assembly removal.
Glass Cleaning
It is necessary to periodically clean glass. During start-
up condensation, which is normal, forms on the inside
of the glass. This condensation causes lint, dust and
other airborne particles to cling to glass surface.
Also initial paint curing may deposit a slight film on the
glass. It is therefore recommended the glass be
cleaned two or three times with a non-ammonia based
household cleaner and warm water (We recommend
gas fireplace glass cleaner) within the first few weeks
of operation.
After the initial cleaning process the glass should be
cleaned two or three times during each operating
season depending on the environment in the house.
Clean glass after first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
Lower Clamps
Window
Frame
Assembly
Pull Clamp
Hook
Push
Clamp
Handle
FP1228
21
Hide quick links:
Advertisement
Table of Contents
