Operating Instructions; Glass Information; Louvre Removal; Window Frame Removal - Majestic 360DVS2 Installation Instructions & Homeowner's Manual

Vermont Castings, Majestic Products, 360DVS Series

Glass Information

Only glass approved by Vermont
Castings, Majestic Products should be
used on this fireplace.
• The use of any nonapproved replacement glass will
void all product warranties.
• Care must be taken to avoid breakage of the glass.
• Under no circumstances should this appliance be
operated without the front glass in place, or with the
glass in a damaged condition.
• Replacement glass (complete with gasket) is
available through your Vermont Castings, Majestic
Products dealer and should only be installed by a
licensed qualified service person.

Louvre Removal

• The top side and top end louvres are removed by
simply lifting the louvre assembly and pulling the
assembly away from the fireplace (Fig. 37).
• The lower side louvres are hinged along there
lower edge and are folded down for access to
components in the base cavity of the fireplace.
• The lower end louvre assembly on the 360DV
S3/ SL/ SR units is removed in the same manner
as the top louvre assemblies.
2.
1.
Fig. 37 Remove louvre assembly top
24

Operating Instructions

LOUVRE
GLASS
PANEL
Louvre removal

Window Frame Removal

Side Window Frame Assemblies
1. Shut off the gas supply.
2. Allow the fireplace to cool if it has been in
operation.
3. Remove the top louvre assembly.
4. Lower the bottom louvre assembly.
5. Release the two clamps along lower edge of the
frame by pulling down on clamp handles (Fig. 38).
6. Tilt lower edge of frame out slightly and lift window
frame assembly up and away from the fireplace.
7. To reinstall the window frame assembly reverse
thisprocedure.
End Window Frame Assembly
1. Remove the top and bottom louvre assembly.
2. Remove the lower window trim (held in place with
magnets).
3. Remove both lower retaining screws. Access to
these screws is gained through the holes along the
lower edge of the frame behind the trim (Fig. 39).
4. Tilt lower edge of frame out slightly and lift window
frame assembly up and away from the fireplace.
5. To reinstall the window frame assembly reverse
the process.
Window
Frame
Assembly
Fig. 38 Window frame assembly removal
Locations of lower
retaining screws
Fig. 39 Retaining screw
Lower clamps
Window
Frame
Assembly
Pull clamp
Push hook
clamp handle
Removable_side
Remove_end
10002547