Lighting And Operating Instructions (Sit80 Valve); For Your Safety Read Before Lighting - Majestic 33LDVR Installation Instructions And Homeowner's Manual

WARNING:If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A. This heater has a pilot which must be lit manually. When
lighting the pilot follow these instructions exactly.
B. BEFORE LIGHTING smell all around the heater area
for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any fireplace
•
Do not touch any electric switch
•
Do not use any phone in your building
•
Immediately call your gas supplier from a
neighbor's phone.
1. STOP! Read the safety information above.
. Turn off all electrical power to the fireplace.
3. Turn the ON/OFF switch to "OFF" position.
4. Open control access panel.
5. Push in gas control knob slightly and turn clockwise
to "OFF".
SIT NOVA
6. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow "B" in the safety information above. If
you do not smell gas, go to the next step.
FP1067
lighting instruction
7. Remove glass door before lighting pilot. (See Glass
knobs
Frame Removal section).
3/9/01 djt
8. Visibly locate pilot by the main burner.
9. Turn knob on gas control counterclockwise
"PILOT".
1. Turn the ON/OFF switch to Off position.
. Turn off all electric power to the fireplace if service
is to be performed.
3. Open control access panel.
10007317
Lighting and Operating Instructions
For Fireplaces Equipped with the SIT820 Valve

FOR YOUR SAFETY READ BEFORE LIGHTING

Lighting Instructions
Honeywell
To Turn Off Gas To Heater
LDVR Series Direct Vent Gas Fireplace
Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the Fire
Department
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, do not try to repair it, call a qualified
service technician. Applying force or any attempted
repair may result in a fire or explosion.
D. Do not use this fireplace if any part has been under
water. Immediately call a qualified service technician
to inspect the heater and to replace any part of the
control system and any gas control which has been
under water.
10. Push the control knob all the way in and hold. Im-
mediately light the pilot by repeatedly depressing the
piezo spark ignitor until a flame appears. Continue
to hold the control knob in for about one (1) minute
after the pilot is lit. Release knob and it will pop back
up. Pilot should remain lit. If it goes out, repeat steps
5 through 8.
3/8" - 1/2"
•
If knob does not pop up when released, stop and
immediately call your service technician or gas
supplier.
•
If after several tries, the pilot will not stay lit, turn
the gas control knob to "OFF" and call your service
technician or gas supplier.
11. Replace glass door.
1. Turn gas control knob to "ON" position.
to
13. Turn the ON/OFF switch to "ON" position or set ther-
mostat to desired setting.
14. Turn on all electrical power to the fireplace.
4. Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
5. Close control access panel.
FP1068
Lighting instructions
Pilots
9