Editing The Arpeggiator - Quasimidi Technox Owner's Manual

12.) Editing the Arpeggiator

12.) Editing the In this section you will learn about TECHNOX' built-in arpeggiator. This arpeggiator splits a chord into
arpeggiator single notes, which then can be played back automatically in different ways. The arpeggiator menu will be
reached by executing the following steps:
Function
Selection of edit level
Selection of „Edit Arpeggiator"
menu.
Confirm selection
Following these steps, the following sub-menus are now available:
|1>
<2>
<3>
<4>
<5>
<6>
<7>
<8>
<9>
The following table shows you the different arpeggiator directions (Sub menu page 7):
1
2
3
4
Use this parameter to switch the arpeggiator on and off.
Arpeggiator\Edit
|1>\Arpegg.:\OFF
Here you can decide if the arpeggiator will be clocked internally or externally.
Arpeggiator\Edit
When switched to external clock, the arpeggiator uses a MIDI clock signal if this
<2>\Sync:\Intern
signal is active on MIDI In of the TECHNOX. If MIDI clock is available, the
arpeggiator will be synchronized to your sequencer.
Here you can select one of the 16 available parts to be controlled by the
Arpeggiator\Edit
arpeggiator.
<3>\Part:\\\\\13
With this parameter the resolution of the arpeggiator will be set. You have the
Arpeggiator\Edit
choice between 4th, 8th, 16th and 32nd notes.
<4>\Resolutn:\16
When using the internal clock (Sync: Intern), the arpeggiator speed is set with this
Arpeggiator\Edit
parameter.
<5>\Speed:\\\\86
Use this parameter to control the gate time (note length) of the arpeggio notes.
Arpeggiator\Edit
This parameter can also be controlled via the modulation matrix.
<6>\Gate:\\\\\64
This parameter controls the direction of the arpeggios. Look at the table below for
Arpeggiator\Edit
the different directions.
<7>\Directn:\\Up
When set to „ON", the arpeggiator chord will be held even if the chord on the
Arpeggiator\Edit
keyboard is depressed. (Sometimes this parameter is also called „LATCH") If set
<8>\Hold:\\\\OFF
to „OFF", the arpeggiator will stop as soon as it receives Note-Off-informations.
The arpeggiator notes can be sent out via MIDI Out of the TECHNOX when this
Arpeggiator\Edit
parameter is set to „ON". This offers you the possibility that other MIDI
<9|\MidiOut:\OFF
synthesizers can also use the TECHNOX' arpeggiator.
Arpeggios start with the lowest note first, the others follow in ascending order.
Direction:\\UP
Arpeggios start with the highest note first, the others follow in descending order.
Direction:Down
Ascending and descending notes consecutively.
Direction:UPDW
The notes are played in random (no) order.
Direction:\RND
User Action/
(Keys/Dials)
Press „EDIT/OK" key
Use one of the two Alpha-dials to
select.
Press „EDIT/OK" key.
Display-Message
\Edit/Function
\Edit/Function
<6>\Edit\Arpegg.
Arpeggiator\Edit
|1>\Arpegg.:\\On
QUASIMIDI STYLEDRIVE FANSEITE
http://people.freenet.de/styledrive/
25