Storing The Newly Created Performance - Quasimidi Technox Owner's Manual

PERFORMANCE-EDITING/STORING A PERFORMANCE
5.) Use the „VALUE/SOUND" dial to select performance-mode.
6.) After the termination of steps 1 to 5, the Edit-System-Menu can be quitted.
(Texte Tabelle 1/21)
Because the TECHNOX is capable of storing several different parameter changes from different edit-menus, it's useful to
list all parameters here for a second time. We also give you a reference to the corresponding sections in the manual where
you can find a detailed description of these parameters. For each performance the following parameters can be memorized:
1
2
3
4
5
10.a.) Storing a
After finishing performance editing, the performance will be saved like follows:
performance
Function
Select „Write/Dump" menu.
Activate sub-menu „Write
performance".
Start saving performance.
Enter new name.
Confirm new name and select
memory position where the
performance shall be stored.
Complete storage of the
performance.
Overwrite old performance.
Quit „Write/Dump" menu.
Edit System
|1> Mode:Perform
The total amount of single-sounds to be used by a performance (Single, Layer 1 to Layer 4) and the main volume
of this performance. (see „Common Menu", pg. 22 ff.)
All effect parameters of the performance (see „Effect editing", pg. 12 ff.)
All part-parameters for part #13 to #16. These parts are used by a performance. (see „Single-Sound-Editing", pg.
9 ff.)
Arpeggiator parameters. (see „Editing the arpeggiator", pg. 25 ff.)
Settings within the „Common Menu". In this menu it is possible to route the different MIDI controllers such as
Modulation, Pitch bend, Aftertouch as well as a user-defined MIDI controller to the different sound parameters.
(see „Common Parameters", pg. 22 ff.)
User action /
(Keys/Dials)
1.) Press „EDIT/OK" key.
2.) Use one of the two Alpha-dials to
select the „Write/Dump" menu.
1.) Press „EDIT/OK" key.
2.) Use „PARAMETER/
SOUNDGROUP" dial to select the
„Write performance" sub-menu.
Press „EDIT/OK" key.
Move cursor with
„PARAMETER/SOUNDGROUP"
dial; select letter with
„VALUE/SOUND" dial.
Press „EDIT/OK" key and select
memory position with
„VALUE/SOUND" dial.
Press „EDIT/OK" key
Press „EDIT/OK" key
Press „EXIT" key until the main
page is displayed
Display-Message
\Edit/Function
<8>\Write/Dump..
|1>\Write\Perf.?
Yes<OK>\No<EXIT>
Name:\Slidox
Yes<OK>\No<EXIT>
Name:\My_Perf
Yes<OK>\No<EXIT>
to\22\<Soloist•>
Yes<OK>\No<EXIT>
Overwr\Soloist•?
Yes<OK>\No<EXIT>
|1>\Write\Perf.?
\\\\\\\\\\ok!
\T_e_c_h_n_o__x
RAM-22:\MyPerf
QUASIMIDI STYLEDRIVE FANSEITE
http://people.freenet.de/styledrive/
21