Quasimidi Technox Owner's Manual page 28

14.) The Edit-System-Menu
<5>
<6>
<7>
<8>
<9>
<10>
<11>
<12>
<13>
<14>
28
Here you can select the velocity curve; i.e. the response characteristics of your
\\Edit\System
TECHNOX in reference to the incoming MIDI note-on velocities. Refer to the
<5>\VelCrv:\Exp+
table below for detailed description of the different velocity curves.
This parameter sets the reception of program change information to on or off.
\\Edit\System
<6>\RxPrgChg:\ON
If set to „ON", incoming program change messages will be interpreted as „Setup"
\\Edit\System
changes. The setup change information has to be sent on the basic channel (see
<7>\RxSetupC:OFF
above); the part that lies on this channel won't respond to program change
informations.
This parameter sets the reception of Aftertouch information to on or off. Notice
\\Edit\System
that any Aftertouch informations will be omitted, even if enabled within the
<8>\RxTouch:\\ON
modulation matrix.
Here the reception of MIDI controller data will be enabled or disabled. Notice that
\\Edit\System
any controller informations will be omitted, even if enabled within the modulation
<9>\RxModul:\\ON
matrix.
Enable or disables the reception of system-exclusive data.
\\Edit\System
<10>\RxParam:\\On
If set to „ON", 'real time' parameter changes (via the „VALUE/SOUND" Alpha
\\Edit\System
dial) will be sent via MIDI Out of your TECHNOX. This enables a sequencer to
<11>\TxParam:OFF
record these parameter changes (for example Filter cutoff, envelope offsets, etc.)
If this function is enabled, control change information (of footswitch controller)
\\Edit\System
will be sent out via MIDI.
<12>\TxFoot:\OFF
This enables or disables the sending of MIDI clock data if the arpeggiator is in use.
\\Edit\System
This allows the TECHNOX to control the tempo of other slave devices (such as
<13>\TxClock:OFF
sequencers, drum-machines, etc.)
If Omni-mode is set to „ON", the TECHNOX will receive MIDI data on all 16
\\Edit\System
channels; but it'll work only in performance mode. Usually you won't need to use
<14>\OmniMod:\On
the Omni mode anyway... When in sequencer mode, this parameter won't appear
because the TECHNOX will then work only in MIDI Multi mode.
QUASIMIDI STYLEDRIVE FANSEITE
http://people.freenet.de/styledrive/