Installation Of Hot And Cold Water Line Fittings - Watts Premier 500029 Installation, Operation And Maintenance Manual

Installation of hot and cold water supply line valves
For 3/8" plumbing
Hand tighten brass nuts then apply 1/4 turn with a wrench.
To Sink Faucet
Supply Hose
(not included)
3/8"M X 1/2"F
Adapter
Rubber
Washer
1/2"M X 3/8"F X 1/4"Comp.
with needle valve
Step 6 Turn off the hot and cold water supply to the faucet by turning the angle stop valves off.
Step 7 Remove water supply line at faucet to the angle stop valves.
Step 8 Attach the water supply line valves as illustrated in the drawings above.
Step 9 Re-attach the water supply line to the fittings attached to the angle stop valves.
To RO System
1/4" Compression Nut
Plastic Sleeve
Brass Insert
Angle Stop Valve
(not included)
RO Tubes will be connected on page 6.
For 1/2" plumbing
To Sink Faucet
Supply Hose
(not included)
1/2"M X 3/8"F
X 1/4"Comp.
with needle valve
3/8"M X 1/2"F
Adapter
Rubber
Washer
5
To RO System
1/4" Compression Nut
Plastic Sleeve
Brass Insert
Angle Stop Valve
(not included)