Planet SGS-5220-24P2X User Manual page 32

L2+24-port 10/100/1000t+4-port shared sfp+2-port 10g sfp+ managed stackable switch sgs-5220 series
Hide thumbs Also See for SGS-5220-24P2X:
Table of Contents

Advertisement

10Gigabit Ethernet Transceiver (10GBase-X SFP+)
Model
Speed (Mbps)
MTB-SR
MTB-LR
1. It is recommended to use PLANET SFP on the Managed Switch. If you insert an SFP transceiver
that is not supported, the Managed Switch will not recognize it.
2. Port 21 to Port 24 are a shared SFP slot that supports the Gigabit and Fast Ethernet SFP
transceiver.
3. Port 25 to Port 26 are a shared SFP+ slot that supports the 10 Gigabit SFP+ transceiver and
Gigabit SFP transceiver.
1.
Before we connect the SGS-5220-24T2X to the other network device, we have to make sure both sides of the SFP
transceivers are with the same media type, for example: 1000Base-SX to 1000Base-SX, 1000Bas-LX to 1000Base-LX.
2.
Check whether the fiber-optic cable type matches with the SFP transceiver requirement.
To connect to 1000Base-SX SFP transceiver, please use the multi-mode fiber cable with one side being the male
duplex LC connector type.
To connect to 1000Base-LX SFP transceiver, please use the single-mode fiber cable with one side being the male
duplex LC connector type.
Connect the Fiber Cable
1.
Insert the duplex LC connector into the SFP/SFP+ transceiver.
2.
Connect the other end of the cable to a device with SFP/SFP+ transceiver installed.
3.
Check the LNK/ACT LED of the SFP/SFP+ slot on the front of the Managed Switch. Ensure that the SFP/SFP+
transceiver is operating correctly.
4.
Check the Link mode of the SFP/SFP+ port if the link fails. To function with some fiber-NICs or Media Converters, user
has to set the port Link mode to "10GForce", "1000 Force" or "100 Force".
Remove the Transceiver Module
1.
Make sure there is no network activity anymore.
2.
Remove the Fiber-Optic Cable gently.
3.
Lift up the lever of the MGB module and turn it to a horizontal position.
4.
Pull out the module gently through the lever.
Connector
Interface
10G
LC
10G
LC
User's Manual of SGS-5220 Series
Fiber Mode
Distance
Multi Mode
300m
Single Mode
10km
32
Wavelength (nm) Operating Temp.
0 ~ 60 ℃
850nm
0 ~ 60 ℃
1310nm

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sgs-5220-24t2x

Table of Contents