Troubleshooting - Gardena TCS Li-18 Operating Instructions Manual

Battery pole pruner
Hide thumbs Also See for TCS Li-18:
Table of Contents

Advertisement

8. Troubleshooting

w
Problem
Pole Pruner does not
start up
Low runtime
Hedge is not cleanly cut
Pole Pruner cannot be
switched off
Pole Pruner stops.
Error-LED
flashes
ß
W
Charging indicator lamp
the charger does not light up
Charging control lamp
on the charger flashes rapidly
(twice per second)
Pole Pruner stops.
Error-LED
is lit
ß
W
The battery can no longer
be charged
Only the original GARDENA Replacement Battery BLi 18 (Art. 9840) may be used.
This can be obtained from your GARDENA dealer or directly from GARDENA Service.
For any other malfunctions please contact the GARDENA service department.
Repairs must only be carried out by GARDENA service departments or specialist
dealers authorised by GARDENA.
24
DANGER! Risk of physical injury!
Cut injury when the Pole Pruner switches on
unintentionally.
v B efore performing troubleshooting work, remove
the battery (see 4. Initial Operation), and slide the
protective cover
snap fit engages.
Possible Cause
Battery is flat.
Battery not pushed onto the
handle properly.
Chain blocked.
Chain tensioned excessively.
Chain not lubricated due to
lack of oil.
Chain dull or damaged.
Start button is stuck.
Battery overload.
High temperature. The allowed
operation temperature was
exceded.
on
Battery charger or charging
9
cable not plugged in properly.
Charging error.
9
Battery error /
battery defective.
Battery is defective.
onto the bar and close until the
w
Remedy
v Charge battery
(see 4. Initial Operation).
v Push battery onto the
handle and make sure that
the locking buttons snaps
in correctly.
v Remove blockage.
v Tension chain
(see 7. Maintenance).
v Refill oil
(see 4. Initial Operation).
v Replace chain.
v Remove battery and loosen
start button.
v Wait for 10 sec.
Press button
battery and restart.
v Leave battery to cool for
approx. 15 min.
Press button
battery and restart.
v Plug in battery charger and
charging cable properly.
v Unplug charger and plug
in again.
v Press button
battery and restart.
v Replace the battery
(Art. 9840).
on the
ß
B
on the
ß
B
on the
ß
B

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tcs li-20

Table of Contents