Troubleshooting; Technical Data - Gardena TCS 720/20 Operator's Manual

1. Lift the chain h off the bar 2
be approx. 2 – 3 mm.
j
2. Turn the adjustment screw
chain is too low, or turn the adjustment screw
the tensioning of the chain is too strong.
3. Start the unit for approx. 10 sec.
4. Check the tensioning of the chain again and re-adjust, if necessary.
6. STORAGE
To put into storage [ Fig. A1 ]:
The product must be stored away from children.
1. Disconnect the mains cable.
2. Clean the unit (see 5. MAINTENANCE) and slide the protective cover
onto the bar 2 and close the snap fit
3. Stow the unit in a dry area where it has protection from frost.

7. TROUBLESHOOTING

DANGER! Risk of injury!
Cut injury when the unit starts accidentally.
v Before you troubleshoot the unit, make sure that the mains
cable is disconnected and the protective cover
the bar 2 and the snap fit 3
Problem Possible Cause
Unit does not start Extension cable not connected
or damaged.
Chain blocked.
Unit can no longer be Start button is stuck.
stopped
Hedge is not cleanly cut Chain dull or damaged.
NOTE: For any other malfunctions please contact the GARDENA service depart-
ment. Repairs must only be done by GARDENA service departments or specialist
dealers approved by GARDENA.

8. TECHNICAL DATA

Telescopic pruner Unit
Motor power consumption W
Mains voltage /
V / Hz
Mains frequency
Motor power consumption m/s
Bar length cm
Chain type px
Oil tank volume ml
Range of extension of
cm
telescopic tube
Weight (approx.) kg
Sound pressure level L
1)
dB (A)
pA
Uncertainty k
pA
Sound power level L
1)
dB (A)
WA
Uncertainty k
WA
Hand / arm vibration a m/s
2) 2
vhw
Measuring process complying with: DIN EN ISO 22868
1)
NOTE: The stated vibration emission value has been measured according to
a standardized test procedure and can be used for comparison of one electric
power tool with another. It can also be used for preliminary evaluation of expo-
sure. The vibration emission value can vary during actual use of the electric power tool.
9. ACCESSORIES
GARDENA Chainsaw Oil For lubrication of the chain.
GARDENA Replacement Chain and bar for replacement.
Chain and Bar
GARDENA Replacement Chain Chain for replacement.
12
in the middle of the bar. The gap should
clockwise when the tensioning of the
j
anticlockwise when
3 .
1 is slid over
is closed [ Fig. A1 ].
Remedy
v Connect the extension cable
or if necessary replace it.
v Remove blockage.
v Disconnect the mains cable
and loosen start button.
v Replace chain.
Value (Art. 8868)
720
230 / 50
13
20
90
100
0 – 45
3.9
89
3.0
102
3.0
1.5 ± 1.5
DIN EN ISO 22867
2)
10. SERVICE
Please contact the address on the back page.
11. DISPOSAL
(in accordance with RL2012/19/EC)
The product must not be disposed of to normal household
waste. It must be disposed of in line with local environmental
regulations.
IMPORTANT!
v Dispose of the product through or via your municipal recycling
collection centre.
1
Art. 6006
Art. 4048
Art. 4049