Operation - Gardena TCS Li-18 Operating Instructions Manual

Filling in chain oil:
0
q
w
Checking the oil lubrication
system:

5. Operation

Working positions:
ß
B
20
DANGER!
Physical injury due to chain breakage when the chain
on the bar is not sufficiently lubricated.
v C heck whether sufficient quantities of chain oil are
We recommend to use Art. 6006 GARDENA Oil or an equivalent
mineral chain oil from a specialist supplier.
1. Unscrew lid of oil tank
2. Fill chain oil into the filler neck
fully filled with oil.
3. Close the lid of oil tank
The device must be cleaned thoroughly if oil has been spilled.
v P oint the bar
of approx. 20 cm. After operating the machine for one minute,
clear traces of oil must be visible on the surface.
Never let the bar come into contact with sand or soil as this
will lead to increased wear of the chain.
The Pole Pruner can be operated in 2 working positions
(above/below). To ensure a tidy cutting edge, thick branches
should be cut in 2 steps (Illustrations similar).
Above
(thick branches):
ß
A
1. From below, saw the
branch to no more
than 1/3 of the dia meter
(chain will push towards
the stop at
the front ).
ß
A
delivered prior to each use.
.
0
again.
0
at a bright wood cutting surface at a distance
e
Above
(thick branches):
2. Cut off the branch
from above (chain
will push towards the
stop at the back
until the viewing window
q
Below:
Cut off from above
(chain will push towards
the stop at the back
).
ß
B
is
w
).
ß
B